23
7. Wind the thread clockwise around the bobbin
four or five times and then pull the thread to
the right to cut it with the cutter.
4. Place the thread through the thread guide
above the spool of thread from back to front.
5. Place the thread through the appropriate
thread guide opening for the spool pin that is
being used.
7
6
5
3
4
GETTING READY
WINDING THE BOBBIN
3. Bring the hinged thread guide up and forward
into the upright position.
6. Pass the thread clockwise around the bobbin
winder tension disc, as illustrated. Make sure
the thread is under the disc securely.
To Next Page
Loading...
