Singer SE300 - Inserting the Bobbin Correctly

18
InSertIng the bobbIn
1. Place bobbin into bobbin case, making sure the bobbin
turns in a counter-clockwise direction.
wIndIng bobbIn Independently
You can wind the bobbin independently while stitching.
1. Insert the auxiliary spool pin into the hole at the left side on
the top of the machine.
2. Place the felt washer and spool of thread onto the auxiliary
spool pin.
3. Bring thread to the right and hook the thread to the thread
guide from rear opening.
4. Follow the normal winding procedure from Steps 2 to 9 (on
page 17).
a
threadIng the machIne
2. Draw thread into notch (a) while holding the bobbin lightly
with your nger.
3. Pull thread along the groove, up and around the top, to the
left, then down.
Pull thread to the right to cut the thread.
4. Replace the bobbin cover. Set the left tabs into the holes in
needle plate and push the right side of bobbin cover down
until it clicks into place.
NOTE:
This machine can start to sew without drawing up the bobbin
thread.
If you want to draw up the bobbin thread, see page 20.
Be sure to use only SINGER Class 15 bobbins (transparent) in
this machine.