Singer SE300 - Presser Foot and Needle Installation

8
The presser foot must be changed according to the stitch
or technique you sew. Information on sewing and sewing
techniques begins on page 21.
CHANGING THE PRESSER FOOT
1. Turn the hand wheel toward you until the needle is at its
highest position.
2. Raise the presser foot lifter.
3. Remove the presser foot by pushing the presser foot
release lever toward you.
4. Place desired foot with its pin directly under the slot in
presser foot holder.
5. Lower the presser foot lifting lever and the presser foot will
snap into place.
removIng the preSSer foot holder
When attaching presser feet that have their own shank, or
when cleaning the machine, you should remove the presser
foot holder.
1. Remove the presser foot.
2. Loosen the presser foot screw and remove the presser foot
holder.
3. To replace the holder, pull up the holder as far as it will go
from bottom of presser bar.
4. Tighten the presser foot screw securely using the
screwdriver.
acceSSorIeS
CAUTION
To prevent accidents:
Turn off the power switch before you change the
presser foot.
NOTE: This sewing machine is a low shank model. When
shopping for optional SINGER presser feet and accessories,
make sure they are designed for low shank models.