Singer SE300 - Pop-Up Messages; Common Machine Status and Error Messages

54
pop-up meSSageS
machIne Set for twIn needle
This pop-up message will appear when
Twin Needle program is activated.
Check the needle and press the “
✓”
button to continue.
thIS StItch cannot be Sewn
wIth twIn needle
This message will appear when a stitch
that cannot be used with twin needle, is
selected.Press the the “
✓”
button and
select another pattern or reset the twin
needle program.
StItch wIdth lImIted for twIn
needle
This message will appear when stitch
width is adjusted to the limit.
Press the the “
✓”
button to continue.
calIbratIon faIled
If calibration has not completed correctly,
pop-up message will appear. Press the “
✓
”
button and retry the calibration.
lower the drop feed lever
When sewing on the button, this pop-up
will appear. Lower the Drop Feed Lever
and press the “
✓”
button to continue.
thIS StItch cannot combIne
Some patterns may not combine into
the sequence. If you select a pattern
that cannot be combined, a message
will appear on screen to alert you of this.
Press the “
✓
” button.
raISe the needle
If the needle is in lowered position and
need to be raised before function can
be executed, this pop-up meesage is
shown. Raise the needle and press the “
✓
”
button to close the pop-up message.
program too long to add
more StItcheS
The sequence can contain a maximum
of 60 patterns and letters. Message will
appear when you came to the limit.
Press the “
✓
” button.
maIn motor overload
If you are sewing on very heavy fabric or
if the machine is blocked when sewing,
the main motor can get overloaded and
the machine will stop sewing. The pop-up
message will close when the main motor
and power supply are secure.
lower the preSSer foot
This pop-up will appear when you start
the sewing without lowering the presser
foot. Press the “
✓
” button and lower the
presser foot lifter to start to sew.
raISe the preSSer foot
This pop-up will appear when the function
has chosen that the presser foot must
be up position. Press the “
✓
” button and
raise the presser foot lifter.
upper thread breakage
When the upper thread breaks or runs
out, this pop-up will appear and sewing
will stop.
Re-thread the upper thread and press “
✓
”
button.
Go back 3-4 stitches backward from
broken point by pressing “-” at sewing
screen.
Press the Start/Stop button to restart
sewing.
thread Jam
If upper or bobbin thread is jammed under
the needle plate, machine will stop and
pop-up this message.
Remove the hoop and needle plate (see
next page) Remove the thread jam and
reset needle plate. Press the “
✓
” button.