SAFETY
1323RD&1623RD Operation Manual 3-11 © Mar. 2022
UNSAFE OPERATION HAZARD
• The waste battery may pose
danger, so do not discard at will. If
it needs to be scrapped, contact a
battery recycling company.
• Except for the professionals, do
not perform a systematic
maintenance or service to the
battery, otherwise it may cause
bodily injuries or damage to the
battery system.
• Except for the professionals, do
not tamper with the settings or
service a signal light when the
system is running, otherwise it
may cause bodily injuries or
damage to the battery system.
• Except for the professionals, do
not remove the battery housing,
otherwise it may cause damage to
the battery system.
NOTICE
It will not covered by the warranty if the battery
attenuates or fails due to customer’s overuse (-
continued use after battery level less than 10%) or
failure to charge the battery for a long time (not timely
charged for 3 days or longer when the battery level
less than 10%).
WELDING AND POLISHING
REQUIREMENTS
Before welding, grinding and polishing operations, al-
ways ensure you read and understand all operation and
maintenance requirements in the Operation Manual
and the Maintenance Manual.
WELDING HAZARDS
• Comply with the welder manufac-
turer’s recommendations for pro-
cedures concerning proper use of
the welder.
• Welding leads or cables may only
be connected after turning off the
power unit.
• Carry out welding operations only
after the welding cable has been
correctly connected.
• Do not use the machine as a
ground wire during welding
operation.
• At all times, make sure that the
power tools are completely stored
in the working platform. Do not
hang the power tools on the rail-
ing of the working platform or the
work area outside the working
platform, or hang the power tools
directly by the wire.
Before performing welding, grinding and polishing work,
welders must seek permission of the responsible de-
partment at the workplace.
AFTER USING THE
MACHINE
1. Choose a safe parking location that is on sturdy,
level ground and that is free of obstructions. Avoid
areas with heavy traffic.
2. Lower the platform.
3. Turn the emergency stop switch of the ground con-
troller to the “OFF” position
4. Turn the key switch to the “OFF” position and re-
move the key to avoid unauthorized use of the
machine.
5. Block the wheels with the wheel wedges.
6. Charge the battery.
NOTICE
After using the machine, the power off switch must
be disconnected.
To Next Page
Loading...
