Sinoboom 1323RD - Operating the Machine; Emergency Stop; Starting the Engine

1323RD&1623RD Operation Manual 7-1 © Mar. 2022
7 OPERATING THE MACHINE
UNSAFE OPERATION HAZARD
Be sure to follow the instructions and
safety rules in this manual. Failure to
follow the instructions and safety
rules in this manual may result in
death or serious injury.
Do not operate this machine unless
you have learned and practiced the
rules for safely operating the ma-
chine as stated in this manual.
• Know and understand the safety
rules before continuing the next
step.
• Avoid dangerous situations.
• Always check the machine before
operating.
• Select appropriate machinery and
personal protective equipment
(hard hats, safety belt and gloves,
etc.) for the task.
• Always perform a pre-operation
function test before using the
machine.
• Check the work site.
• Check the safety decals/ name-
plate on the machine.
• Only use the machine according
to the instructions in this manual
and for its intended purpose.
This section provides specific instructions for all the as-
pects of machine operation. The operator is responsible
for following all the safety rules and instructions in this
manual.
Use this machine to transport people and tools to the
workplace. It is unsafe and dangerous to use this ma-
chine for purposes other than what is stated in this
manual.
Only trained and authorized personnel may operate the
machine. If more than one operator uses the same ma-
chine at different times of the same work shift, they
must all be qualified operators and follow all the safety
rules and instructions in this Operation Manual.
Each new operator must perform the pre-operation in-
spection, pre-operation function test, and workplace
checks before using the machine.
EMERGENCY STOP
1. Push in the emergency stop button on the platform
controller and ground controller to OFF, all functions
will be inoperative.
2. Push the power-off switch on the left side of chassis
to OFF, all functions will get inoperative.
Figure 7-1
3. To restore operating any function, return the
emergency stop buttons and power-off switch to
their original positions.
NOTICE
If the platform controller displays the number “02”,
push in the emergency stop button immediately.
STARTING THE ENGINE
1. From the ground controller, turn the key switch to
the intended position.
2. Ensure the red emergency stop buttons on ground
and platform controllers are pulled out to ON
position.
3. Press the engine start switch.