Sinoboom 1323RD - Table of Contents

1323RD&1623RD Operation Manual i © Mar. 2022
TABLE OF CONTENTS
Introduction ............................. iii
1 Machine Specifications ........ 1-1
2 Machine Components .......... 2-1
3 Safety ............................... 3-1
Safety Definitions . . . . . . . . . . . . . . . . . . . . . 3-1
Reporting Accidents. . . . . . . . . . . . . . . . . . . 3-1
Electrocution Hazards. . . . . . . . . . . . . . . . . 3-2
Tipping Hazards and Rated Load . . . . . 3-2
Work Environment Hazards . . . . . . . . . . . 3-4
Unsafe Operation Hazards. . . . . . . . . . . . 3-5
Fall Hazards. . . . . . . . . . . . . . . . . . . . . . . . . . . 3-6
Collision Hazards . . . . . . . . . . . . . . . . . . . . . 3-7
Crush Hazards . . . . . . . . . . . . . . . . . . . . . . . . 3-8
Explosion and Fire Hazards. . . . . . . . . . . 3-8
Damaged Machine Hazards . . . . . . . . . . 3-8
Bodily Injury Hazards . . . . . . . . . . . . . . . . . 3-9
Battery Hazards . . . . . . . . . . . . . . . . . . . . . . . 3-9
Welding and Polishing Requirements 3-11
After Using the Machine. . . . . . . . . . . . . . 3-11
4 Jobsite Inspection............... 4-1
5 Pre-operation Inspection ...... 5-1
Tips for Conducting a Pre-operation
Inspection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1
Conducting a Pre-operation
Inspection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-2
Inspecting Parts . . . . . . . . . . . . . . . . . . . . . . . 5-2
Inspecting Entire Machine . . . . . . . . . . . . 5-2
Inspect Hydraulic Oil Level . . . . . . . . . . . . 5-3
Inspecting Engine Oil Level . . . . . . . . . . . 5-3
Inspecting Fuel Level . . . . . . . . . . . . . . . . . 5-4
Inspecting Coolant Level (water-
cooled engine) . . . . . . . . . . . . . . . . . . . . . . . . 5-5
Inspecting the Battery . . . . . . . . . . . . . . . . . 5-6
6 Pre-operation Function Test .. 6-1
Testing the Ground Controller (DTC
System) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-1
Preparation . . . . . . . . . . . . . . . . . . . . . . . . . 6-3
Ground/Platform select switch . . . . . . 6-4
Engine start switch. . . . . . . . . . . . . . . . . . 6-4
Emergency stop button . . . . . . . . . . . . . 6-4
Glow plug switch. . . . . . . . . . . . . . . . . . . . 6-4
Engine speed select switch . . . . . . . . . 6-4
Platform up/down function . . . . . . . . . . 6-4
Emergency lowering . . . . . . . . . . . . . . . . 6-5
Regeneration function . . . . . . . . . . . . . . 6-5
Testing the Ground Controller (-
Sinoboom Control System) . . . . . . . . . . . 6-5
Preparation . . . . . . . . . . . . . . . . . . . . . . . . . 6-7
Ground/Platform select switch . . . . . . 6-8
Ignition switch. . . . . . . . . . . . . . . . . . . . . . . 6-8
Emergency stop button . . . . . . . . . . . . . 6-8
Glow plug switch. . . . . . . . . . . . . . . . . . . . 6-8
Engine speed select switch . . . . . . . . . 6-8
Platform up/down function . . . . . . . . . . 6-8
Emergency lowering . . . . . . . . . . . . . . . . 6-9
Regeneration function . . . . . . . . . . . . . . 6-9
Testing the Platform Controller (DTC
System) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-9
Preparation . . . . . . . . . . . . . . . . . . . . . . . . 6-11
Engine start switch. . . . . . . . . . . . . . . . . 6-11
Emergency stop button . . . . . . . . . . . . 6-11
Engine preheat switch . . . . . . . . . . . . . 6-11
Horn button . . . . . . . . . . . . . . . . . . . . . . . . 6-11
Lighting switch (optional) . . . . . . . . . . 6-11
Engine speed select switch . . . . . . . .6-12
Hydraulic generator switch (if
equipped) . . . . . . . . . . . . . . . . . . . . . . . . . .6-12
Platform lift switch . . . . . . . . . . . . . . . . .6-12