Operation instructions
SIPOS SEVEN ECOTRON
Page 54 Y070.301/EN
9 Index
9
Index
Signal cable. ........................ 11
Signaling gear. ....................... 6
Prerequisite for adjustment. .......... 36
Transmission ratio. ................. 36
Transmission ratio adjustment. ........ 36
Signaling gear ratio. .................. 36
Signals
Status. ........................ 16, 17
Spare parts. ........................ 45
Spare parts list. . . . . . . . . . . . . . . . . . . . . . . 45
Special parameters
DC link voltage limitation. ............ 33
End position speed. . . . . . . . . . . . . . . . . . 33
Runtime monitoring. ................ 33
Speed. .....................see Speeds
Speed in end positions. ............... 33
Speeds. ........................... 30
State indications. ................. 16, 17
Status and fault signals. ............... 17
Status indication (LED). ............... 16
Stem protection tube. .............. 10, 13
Storage. ............................ 4
Storage temperature. .................. 4
Sub-assemblies. ...................... 7
Electronics unit. ..................... 7
Gear unit. ......................... 7
Supplementary operation instructions. ..... 5
Symbols. ............................ 4
Electrostatics. ...................... 4
In the display. ..................... 19
LEDs. ........................... 15
Notice. ............................ 4
Warning. .......................... 4
Working steps by valve manufacturers. .. 4
Symbols in display. ................... 19
T
Temperature during storage. ............ 4
Transport. ........................... 4
Tripping torque. ..................... 28
U
USB port. .......................... 24
V
Valve travel. ........................ 36
Viewing parameter settings. ............ 42
W
Warnings on the device. ................ 3