Sirona Sinius CS - Water Unit

63 22 726 D3561
D3561.201.01.03.02 05.2012
137
Sirona Dental Systems GmbH 4 Operation
Operating Instructions SINIUS / SINIUS CS 4.7 Water unit
båÖäáëÜ
1. Press and hold the Aqua key (> 2 s).
 The
Aqua key flashes orange. Moreover, the Changing to self-
sufficient water supply
display appears.
 If disinfectant is still found in the reservoir, this is rinsed into the
drain. Then the
Refilling water display appears on the
touchscreen.
2. Mixing distilled water with the DENTOSEPT P disinfectant in a 100:1
ratio (1 liter of water, 10 ml DENTOSEPT P) and fill this into the
disinfectant tank of the water unit. The tank has a capacity of approx.
1.3 liters. It is full when the water surface is visible at the filter of the
funnel tube.
 In the
Start sub-screen, the Aqua key is highlighted in orange.
The disinfection system is now changed to the self-sufficient
water supply.
If the treatment center is changed to self-sufficient water supply, the
Sanitation key is hidden in the Start sub-screen. Sanitation of the water
lines without disinfectants is no longer possible.
Resetting disinfection system for operation with municipal water and
disinfectants
Resetting the disinfection system to municipal water is performed in a
similar way to changing to the self-sufficient water supply. Instead of the
Refilling water display, the Refilling disinfectant display appears on the
touchscreen.
Link to "Sanitizing the treatment center", SINIUS
➢ Carry out sanitation of water lines after changing to municipal water,
see “Sanitizing treatment center” [ → 207].
Level control
If the Refilling water or Refilling disinfectant display appears during the
treatment, the reservoir is almost empty (< 300 ml). By pressing the
Return key, the display can be hidden and the treatment can be
continued. Refill the reservoir as soon as possible.