Need help?Do you have a question about the Sirona S2 and is the answer not in the manual?
General| Brand | Sirona |
|---|---|
| Model | S2 |
| Category | Medical Equipment |
| Language | English |
Explains the display indicators for unit status and modes.
Details functions of the left control panel keypad, including spray and chip blower.
Describes functions of the center control panel keypad, including chair programs.
Explains functions of the right control panel keypad for manual chair adjustments.
Instructions for switching the unit's power supply on and off safely.
How to adjust the headrest and select operator profiles.
Information on amalgam rotor maintenance and disinfection system usage.
How to use the foot switch to preselect, navigate, and activate functions.
How to move the dentist unit up or away using the foot switch.
How to start instruments using the foot switch.
How to select pre-programmed patient positions using the unit lamp.
Detailed steps for reprogramming the four factory-set patient positions.
Manual adjustment of headrest, backrest tilt, and chair height.
How to set the foot switch to direct starter or speed controller mode.
How to control spray, chip blower, and instrument light intensity.
Settings for SIRONA motor, turbine air pressure, and SIROSON L scaler.
Operating the SIROTOM electrosurgery and SPRAYVIT handpieces.
Controls for unit lamp, tumbler filling, cuspidor rinsing, and amalgam test.
Procedures for flushing water paths for hygiene and maintenance.
Configuring NaCl pump, time, date, and foot control modes.
Adjusting light voltage, drive intensity, cooling air, language, and SIROLUX.
Preparing the unit for procedures involving saline solution.
Functions of the assistant unit's control panel keypads.
Operation of water unit, suction handpieces, and coolant supply.
Installation, handling, operation, and safety of the POLYLUX light.
Connecting additional equipment to the chair's media block.
To Next Page