Sirona Dental Systems GmbH 10 Instrument Functions
41 63 189 D 3311
D 3311.201.01.10.02
29
IRKPMWL
Safety checks according to MPG
The following safety checks must be made
every 12 months in compliance with DIN
VDE 0751/10.90:
• Visual inspection of the unit and
accessories for mechanical damage
impairing operation, especially of the
radio-frequency leads.
• Check of the fuses accessible from the
outside for nominal data.
• General functional check
• Check of the acoustic and optical
displays
• Protective ground wire test according
to DIN VDE 0751/10.90
• Measuring the equivalent leakage cur-
rent according to DIN VDE 0751/10.90
10.6 SPRAYVIT
When the SPRAYVIT is removed from its
hanger and started, only the operator
(A
or B) appears on the display. It is then
only possible to preselect instrument light
YES/NO and adjust the brightness. If pre-
selected, the instrument light automatically
switches on when the SPRAYVIT is actu-
ated. The light automatically switches back
off when the handpiece is returned to its
hanger
10.7 Storing Fixed Settings
Remove an instrument from its hanger and
set it according to your wishes.
Example: SIRONA motor:
40,000 min
-1
CW rotation,
with cooling spray,
with instrument light.
To store the settings, hold down key
A/B
for
approx. 3 sec. An acoustic signal then
sounds to indicate that the settings have
been successfully saved. These settings
are then activated whenever the instrument
is removed from its hanger.
Both operators (
A
and
B
) can store the
various settings they require for their
individual instruments.
A
A
RPM
To Next Page
Loading...
