Sirona S2 - Specialized Procedures and Equipment; Surgery with Saline Solution

Sirona Dental Systems GmbH 13 Surgery with Saline Solution NaCl
41 63 189 D 3311
D 3311.201.01.10.02
37
IRKPMWL
13
Surgery with Saline Solution NaCl
Preparation of unit
• Hang NaCl bottle (1) in place.
• Attach peristaltic pump set (2).
• Push short end of hose (3) with cannula
as shown through stopper and into
NaCl bottle.
• The regulator in the hose clip (4) must
be in the top position (completely
open).
•
Run long hose (5) along corresponding
motor hose up to the angle piece and
fasten with clips (6).
• Fit coupling (7) onto hose and connect
it with thin silicone hose (8).
• Connect spray clip (9) with thin hose
and attach to angle piece.
The
peristaltic pump set (2)
is a
disposable article, it can be purchased as
consumable material under the article num-
ber F 58707 directly from the manufacturer
in packs of 10 pcs.
Purchase address:
Fa. Satelec
Industriestr. 9
40822 Mettmann
NOTE
Preselection
of the hanger for the
instrument with saline solution is described
under
"Basic Workstation Settings with
Mode Key"
on p. 32.
After a handpiece is removed from its
hanger, the
NaCl pump
can be switched
ON/OFF
by pressing the
with/without
spray
key (or footswitch towards the left).
When the green LED of the key lights up,
the NaCl pump is switched ON.