FT24 User Manual V1.1
15
2020 SIYI Tech All Rights Reserved
2.2.4 Digital Trim
⚫ There are 6 digital trim switches on FT24 transmitter, which support continuous
trimming of 6 channels.
⚫ Each trim switch has two direction to go, left to right, or up to down, the same
with their mapped channels.
⚫ Every time you push the trim switch to one direction, the trimming position
moves according to the pre-set stepping value. If you push and hold the trim
switch, the trimming position will speed up to move. When the trimming
position reaches the middle, there is a special sound.
Mark: Please refer to the chapter “Trim Settings” in this manual for more detail.
To Next Page
