SIYI FT24 - Steps of Wireless Trainer

FT24 User Manual V1.1
49
2020 SIYI Tech All Rights Reserved
5. After defining, the switch takes over control of turning on / off trainer mode, so
that master transmitter can take over control from slave transmitter in emergency.
6. If you turn on Joystick Control, master transmitter will take over control
immediately by operating joysticks.
5.11.2 Steps of Wireless Trainer
1. Go to “Trainer Mode” page. It displays a list of all 16 channels.
2. Turn FUNC to “Wireless” and assign “Master” transmitter and “slave” transmitter.