FT24 User Manual V1.1
3
2020 SIYI Tech All Rights Reserved
Always power off your aircraft/vehicle/model first, FT24 transmitter the second.
Before changing any settings on the transmitter, make sure your
aircraft’s/vehicle’s/model’s engines are powered off and their motor wires are off connection,
in case of a sudden switch-on.
When you start your aircraft/vehicle for the first time, make sure that the fail-safe
settings in your transmitter is activated.
Always switch on the transmitter first and hold the throttle joystick at its bottom
position, then power on your aircraft/vehicle/model.
1.3 Batteries
FT24 transmitter is powered by external batteries. Please do read the
precautions below before selecting your battery models.
The transmitter Micro-USB port does not support charging.
Make sure that the battery power, voltage, and volume are compatible with FT24
transmitter’s requirement:
2 x 18650 Li-on Batteries
or
1 x 2S LiPo Battery (XH 2.54 3-pin Port)
Stop using the battery immediately if you found it smoking, overheat, or expanded.
Stop using the transmitter immediately if there was a peculiar smell, smokes, or leaks.
In such cases you shall sent the transmitter back to your dealer for after-sales service.
To Next Page
Loading...
