FT24 User Manual V1.1
47
2020 SIYI Tech All Rights Reserved
Mark: FT24 is already configured of some programming and mixing types for delta
wing and differential cars/boats. Please refer to “Chapter 5.3 Model Type” for detail.
5.11 Trainer Mode (Master-Slave)
Trainer Mode (Master-Slave) helps experienced RC hobbyists train new talents.
Under this mode, two FT24 transmitters can be linked through a trainer cable or be
linked wirelessly. All channels are open for trainer mode, users decide which
channel to use, and through a physical switch you can switch between master
transmitter and slave transmitter.
About Trainer Mode
To Next Page
Loading...
