FT24 User Manual V1.1
48
2020 SIYI Tech All Rights Reserved
FUNC (Function)
OFF to turn off.
Wired to use trainer cable. Wireless to use wireless trainer.
MODE
Switch between master transmitter and slave transmitter.
CTL SW (Control Switch)
Define a physical switch to switch between master transmitter and slave transmitter.
JOY CTL (Joystick Control)
ON to take over control from slave transmitter on mater transmitter.
OFF to give back control to slave transmitter.
LINK
Bind master transmitter to slave transmitter.
5.11.1 Steps through Using Trainer Cable
1. Use trainer cable to connect the two AUDIO ports of master transmitter and
slave transmitter.
2. Go to “Trainer Mode” page. It displays a list of all 16 channels.
3. Turn FUNC to “Wired” and assign “Master” transmitter and “Slave” transmitter.
4. When you are to define a physical switch for trainer mode control, tap on “NULL”,
it displays “select a switch by operating it”. Then operate a switch, it goes to
switch status page for defining its stages.
To Next Page
Loading...
