FT24 User Manual V1.1
44
2020 SIYI Tech All Rights Reserved
5.9 Fail Safe
After binding FT24 transmitter to its receiver, do not forget to configure Fail-Safe
and turn on the function. Then if your transmitter lost control to receiver, Fail-Safe
function runs automatically and immediately to protect your model from a crash.
Steps
1. Please make sure that FT24 transmitter is bond to receiver.
2. Go to “Model”, enter “Fail Safe”.
3. The page displays information as in the picture below.
4. In Fail-Safe page, the function is default to be “OFF” and it displays “HOLD” in
each channel. Under this configuration, if transmitter lost control to receiver, the
To Next Page
Loading...
