FT24 User Manual V1.1
50
2020 SIYI Tech All Rights Reserved
3. When you are to define a physical switch for trainer mode control, tap on “NULL”,
it displays “select a switch by operating it”. Then operate a switch, it goes to
switch status page for defining its stages.
4. After defining, the switch takes over control of turning on / off trainer mode, so
that master transmitter can take over control from slave transmitter in emergency.
5. If you turn on Joystick Control, master transmitter will take over control
immediately by operating joysticks.
6. Start linking/binding master transmitter to slave transmitter by tapping on “LINK
- Start”. Transmitter indicator turns to blink red fast. Then repeat the operation
on slave transmitter, linking/binding is finished when transmitter indicator turns
to green.
7. Wireless trainer setting is finished successfully.
Mark:
Slave Transmitter Indicator Green: Master and slave transmitter in communication.
Slave Transmitter Indicator Yellow: Master and slave transmitter off communication.
Master Transmitter Indicator Green: Master transmitter and receiver in communication.
Master Transmitter Indicator Yellow: Master transmitter and receiver off communication.
To Next Page
Loading...
