FT24 User Manual V1.1
54
2020 SIYI Tech All Rights Reserved
Steps
1. Push throttle stick to a target position, then tap on “ENT” to pick a point.
2. Select a picked point, then use “+” or “-” button to adjust its position on X axis or
Y axis.
3. Turn “CTL” to “ON” to turn on Throttle Curve function.
4. Tap on “NULL” to define a physical switch to switch curves. If no switch defined,
curve mode stays in “Normal”.
Mark: Pitch Curve function shares the same steps with Throttle Curve.
To Next Page
Loading...
