FT24 User Manual V1.1
71
2020 SIYI Tech All Rights Reserved
2. Enter “Start”, the page will ask you to confirm if “both knobs are in middle
position”.
3. Adjust both knobs to make them stay in middle position (channel value is 0),
then enter “Next”. The page will show “Calibrating” and “Do not operate”.
4. Do not operate on any knob until the page asks you to operate “both knobs to
maximum and minimum position”. Follow the hint and repeat it for several times.
5. Enter “Finish” when all steps are done.
To Next Page
Loading...
