FT24 User Manual V1.1
83
2020 SIYI Tech All Rights Reserved
Preparation
1. Power on receiver, turn on both transmitter and receiver.
2. Bind transmitter with receiver and make sure the system is working well.
Steps to Calibrate RX Voltage
1. Power on the receiver through any PWM port. Voltage range: 3.6 – 10 V.
2. Let’s take an example of 6.0 V.
Go to “Voltage Calibration - RX” page, enter “Cali Volt” and use “+” and “-”
buttons to input “6.0 V” as a standard voltage to calibrate.
3. Enter “SET”, receiver telemetry voltage calibration is done when the page
displays the same information.
Steps to Calibrate PWR Voltage
1. Power on the receiver through any PWM port. Voltage range: 0 – 50 V (FR
Receiver). 0 – 26 V (FR Mini Receiver).
2. Let’s take an example of 25.0 V.
To Next Page
