FT24 User Manual V1.1
85
2020 SIYI Tech All Rights Reserved
Steps
1. Power on both FT24 transmitter and FR receiver. Make sure they are bond and
working well.
2. The default PWM channel setup is like below.
PWM 1 = Receiver PWM 1
PWM 2 = Receiver PWM 2
…
3. Go to “PWM Settings” page, select a target PWM channel and use “+” and “-”
buttons to input a target transmitter channel.
4. Enter “SET”, PWM settings is finished when the page displays the same
information.
To Next Page
Loading...
