1. Safety instructions
The operator of the described product
must ensure that the owner’s manual are
read and understood by all persons tasked
with the assembly, operation,
maintenance, and repair of the product.
The owner’s manual must be kept readily
available.
Note that the owner’s manual form part of
the product and must accompany the
product if sold to a new owner.
The described product is manufactured in
accordance with the generally accepted rules and
standards of industry practice and with occupational
safety and accident prevention regulations. Risks
may, however, arise from its usage and may result
in physical harm to persons or damage to other
material assets. Therefore the
product may only be used in proper technical
condition and in observance of the owner’s manual.
In particular, any malfunctions which may affect
safety must be remedied immediately.
In addition to the owner’s manual,
statutory regulations and other general
regulations for accident prevention and
environmental protection must be
observed and applied.
1.1. Intended use
All products from SKF Lubrication Systems
Germany GmbH may be used only for
their intended purpose and in accordance
with the information in the product's
owner’s manual.
The described product is for supplying centralized
lubrication systems with lubricant and is intended
for use in centralized lubrication systems. Any other
use of this product constitutes improper use.
Hazardous materials of any kind, especially the
materials classified as hazardous by CLP Regulation
EC 1272/2008 may only be used to fill SKF
centralized lubrication systems and components and
deliv-ered and/or distributed with the same after
consulting with and receiving written approval from
SKF.
None of the products manufactured by SKF
Lubrication Systems Germany GmbH can be used
with gases, liquefied gases, gases dissolved under
pressure, steams or fluids that will reach a steam
pressure of more than 0.5 bar above the normal
atmospheric pressure (1013 mbar) in the permis-
sible application temperature range.
Unless specially indicated otherwise, products from
SKF Lubrication Systems Germany GmbH are not
approved for use in potentially explosive areas as
defined in the ATEX Directive 94/9/EC.
1.2. Authorized personnel
The products described in the installation instruc-
tions may only be installed, operated, maintained,
and repaired by qualified experts. Qualified experts
are persons who have been trained, instructed, and
familiarized with the end product into which the
described product is installed. These persons are
considered capable of such tasks due to their
education, training, and experience with valid
standards, conditions, accident prevention regula-
tions, and installation measures. They should be
able to carry out the required tasks and to recognize
- and thus avoid - any dangers that might otherwise
occur.
A definition of what constitutes a qualified person
and who are unqualified persons are stipulated in
DIN VDE 0105 and IEC 364.
To Next Page
Loading...
Need help?
General
