9. Maintenance
9.1. General notes
Danger!
Performing work on an energized pump or
product may result in serious injury or
death. Assembly, maintenance, and repair
work may only be performed on products
that have been de-energized by qualified
technical personnel. The supply voltage
must be switched off before opening any of
the product's components.
Danger!
Centralized lubrication systems are
pressurized during operation. Centralized
lubrication systems must therefore be
depressurized before starting assembly,
maintenance or repair work, or any system
modifications or system repairs.
Danger!
The described product is pressurized
during operation. The product must
therefore be depressurized before starting
assembly, maintenance or repair work, or
any system modifications or system
repairs.
Products from SKF Lubrication Systems Germany
GmbH are low-maintenance. However, all
connections and fittings must be regularly inspected
for proper seating to ensure proper function and to
prevent hazards from arising.
SKF Lubrication Systems Germany GmbH shall not
be held liable for damages resulting from improperly
performed assembly, maintenance or repair work on
the product.
9.2. Cleaning
If necessary, the product can be cleaned using mild
cleaning agents that are compatible with the
product's materials (non-alkaline, non-soap). For
safety reasons, the product should be disconnected
from the power supply and the hydraulic and/or
compressed air supply.
Do not allow any cleaning agent to enter the interior
of the product during cleaning.
It is not necessary to clean the interior of the
product if the product is operated normally and
intercompatible lubricants are used.
The interior of the product must be cleaned if
incorrect or contaminated lubricant is accidentally
filled into the product. If this occurs, please contact
the Service department of SKF Lubrication Systems
Germany GmbH for assistance.
Dismantling of the product or individual
parts thereof within the statutory warranty
period is not permitted and voids any
claims.
9.3. Replacing the pump element
Only original spare parts from SKF
Lubrication Systems Germany GmbH may
be used. Unauthorized alterations to
products and the use of non-original spare
parts and accessories are prohibited and
nullify the statutory warranty.
Too little or no lubricant will be delivered if a pump
element is worn out. After removing the main
lubricant line and the pressure regulating valve, you
can keep the outlet port of the pump element closed
with a finger when the piston pump unit operates to
deliver lubricant. This is a sign that the element is
worn.
To Next Page
Loading...
Need help?
General
