SKF KFA1 series User Manual

7. Electronic control unit Page 46
EN
7.1.4. Operation of KFAS (industrial and
commercial vehicles)
7.1.4.1. LED displays on the control screen
during operation (KFAS)
During operation, you should regularly check the
LED displays on the control unit's control screen (
Table26).
Further information about the operating state and
the set parameters can be queried in display mode
( next Chapter).
Table 26. LED displays on the control screen during operation (KFAS)
LED
LED lights up
Operating voltage is present on the piston pump unit and the control unit.
The centralized lubrication system is currently in the interval time.
Operating voltage is present on the piston pump unit and the control unit.
The centralized lubrication system is currently in the contact time.
During the contact time:
Progressive distributor monitoring using one cycle switch is active.
Not assigned
Fault
The operational sequence has been stopped or
the piston pump unit is currently in block mode ( Chapter 3.5.6, "Block mode").
Additional information can be accessed by pressing or
( Chapter 7.1.5, "KFAS fault indications").

SKF KFA1 series Specifications

General

Brand	SKF
Model	KFA1 series
Category	Water Pump
Language	English