Page 73
EN
Change code
Step Key Display
1 Display flashes
(000 = factory setting)
Press for more than 2 s
2 Key number is selected
Press briefly (321 = factory default setting)
(confirm code)
3 Display flashes
Press briefly
(confirm key) (000 = factory setting)
4
Press briefly Display flashes
(confirm code)
5 new code is set
Example: 666
Press either until Warning! Do not enter 321.
6
Press briefly Confirm new code
7 New code is written to memory
Press for more than 2 s and the display clears
10.5 Change access code
This factory default code is now deleted
and the new value is valid. Write down
the new value and store it in a safe
place. The parameters cannot be pro-
grammed if the code is lost or forgotten.
In this case, the pump unit must be
sent to the dealer or authorized SKF
Do not enter the digits 321 as the new
code.
10. KFGS programming
KFGS
To Next Page
Loading...
Need help?
General
