Ski-Doo SCANDIC WT - 10 Engine Cut-Out Switch; 11 Headlamp Dimmer Switch; 12 Rewind Starter Handle; 13 Choke Lever

10) Engine Cut-Out Switch
To stop the engine in an emergen-
cy, push the button to the lower po-
sition (OFF) and simultaneously apply
the brake. To restart, button must be
at the upper position (ON).
1
A17G1DA
2
1. ON
2. OFF
All operators of the snowmobile
should familiarize themselves with
thefunctionofthisdevicebyus-
ing it several times on first outing
and whenever stopping the engine
there-after. This engine cut-out pro-
cedure will become a reflex and will
prepare operators for emergency situ-
ations requiring its use.

WARNING
If the switch has been used in an
emergency caused by a suspect-
ed malfunction, the source of the
malfunction should be determined
and corrected before restarting en-
gine. See an authorized SKI-DOO
dealer for servicing.
11)Headlamp Dimmer
Switch
Located on left hand side of handlebar,
allows selection of headlamp beam.
Note that lights are automatically ON
whenever the engine is running.
A33E04A
12) Rewind Starter Handle
All Models except V800
Auto-rewind type located on right
hand side of snowmobile. To engage
mechanism, pull handle slowly until a
resistance is felt, then pull vigorously.
Slowly release handle.
13) Choke Lever
550F and 600 Models
See proper usage instructions in
STARTING THE ENGINE in OPER-
ATING INSTRUCTIONS section.
This device features a 3-position lever
to facilitate cold start.
1
2
3
A06H1KA
1. OFF
2. Position 2
3. Position 3
_____________________
39