EasyManua.ls Logo

Ski-Doo SCANDIC WT - Snowmobile Cannot Reach Full Speed

Ski-Doo SCANDIC WT
135 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TROUBLESHOOTING
ENGINE OVERHEATING (fan cooled)
1. Engine is too hot, shut off the engine.
Check for clogged air duct passages. Remove any foreign materials.
Check for proper fan belt condition and tension. See an authorized
SKI-DOO dealer.
ENGINE OVERHEATING (liquid cooled)
1. Engine overheating pilot lamp will light up if engine is too hot.
Reduce snowmobile speed and run snowmobile in loose snow or stop en-
gine immediately.
Check for adequate coolant level. See an authorized SKI-DOO dealer.
2. Radiator fan inopenative (V800 models).
Check fuse 10.
FUEL FLOODED ENGINE
1. Never depress throttle while starting engine, even if flooded with gas.
Install new spark plugs and restart engine.
REAR SUSPENSION SLIDER SHOE STICKING
1. Slider shoes are cooled and lubricated by snow. When riding at moderate
or high speed on a thin-snow-covered surface, slider shoes may stick on
metallic track guides.
Run snowmobile on a surface covered by snow or drive snowmobile at very
slow speed.
Have slider shoes inspected by an authorized SKI-DOO dealer.
ENGINE CRANKS BUT FAILS TO START
1. Ignition switch or engine cut-out switch is in OFF position or tether cord
cap (DESS key) away from its post.
Place engine cut-out switch in t
he ON position (up) and install tether cord
cap (DESS key) on its post.
2. Mixture not rich enough to sta
rt cold engine.
Check fuel tank level and che
ck starting procedure, particularly use of the
choke.
3. Flooded engine (spark plu
g wet when removed).
Do not choke. Remove wet s
park plug, turn ignition switch or engine cut-
out switch to OFF position and crank engine several times. Install clean
dry spark plug. Start engine following usual starting procedure. If engine
continues to flood
, see an authorized SKI-DOO dealer.
4. No fuel to the engine (spark plug dry when removed).
Check fuel tank level; check fuel filter; replace if clogged; check condition
of fuel and impul
se lines and their connections. A failure of the fuel pump,
throttle body or carburetor has occurred. Contact an authorized SKI-DOO
dealer.
_____________________
67

Table of Contents

Related product manuals