EasyManua.ls Logo

Ski-Doo SCANDIC WT - Engine Starting Procedure (600 HO SDI)

Ski-Doo SCANDIC WT
135 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BREAK-IN PERIOD
Engine
CAUTION: Abreak-inperiodof
10 operating hours 500 km
(300 miles) is required before
running the snowmobile at full
throttle.
During break-in period, maximum
throttle should not exceed 3/4 open-
ing. However, brief full acceleration
and speed variations contribute to a
good break-in.
CAUTION: Engine overheating,
continued wide open throttle runs
and prolonged cruising without
speed variations should be avoid-
ed, this can cause engine damage
during the break-in period.
550F and 600 Models
To assure additional protection dur-
ing the initial engine break-in, 500 ml
(18 imp. oz) of recommended injec-
tion oil should be added to fuel for the
first full filling of fuel tank. Have spark
plugs cleaned after engine break-in.
Belt
All Models
A new drive belt requires a break-in pe-
riod of 50 km (30 miles). Avoid strong
acceleration/deceleration, pulling a
load or high speed cruising.
10-Hour Inspection
NOTE: The 10-hour inspection is at the
expense of the snowmobile owner.
As with any precision piece of me-
chanical equipment, we suggest that
after the first 10 hours of operation or
500 km (300 miles), whichever comes
first, your snowmobile be checked by
an authorized SKI-DOO dealer. This in-
spection will also give you the opportu-
nity to discuss the unanswered ques-
tions you may have encountered dur-
ing the first hours of operation.
_____________________
51

Table of Contents

Related product manuals