Skyjack SJ12 User Manual

33
SJ12, SJ16 213721AAA
Visual and daily maintenance inspections Section 4 – Inspections Before Operation
4.2-4 Wheel/tire assembly
Do the inspection that follows:
1
Wheel/tire assembly
▪
Do a check on all the tire treads and sidewalls
for cuts, cracks, and unusual wear.
▪
Do a check on each wheel for damage, and
cracked welds.
▪
Make sure the wheels are correctly aligned
vertically and horizontally.
▪
Make sure there is no visible damage.
WARNING
Do not use tires other than the tires that Skyjack
species for this MEWP. Do not mix different types
of tires or use tires that are not in good condition.
Only replace the tires with the same types that are
approved by Skyjack. The use of other tires can
make the MEWP less stable. If you do not obey,
there is a risk of death or serious injury.
2
Wheel nuts
▪
Make sure the castle nut is in position and is
tight.
▪
Make sure the cotter pin is correctly installed.
4.2-5 Base
Do the inspection that follows:
3
Base weldment
▪
There are no cracks in the welds or structure.
▪
There are no signs of deformation
4
Steer cylinder assembly
▪
The steer cylinder assembly is correctly
installed.
▪
There are no loose or missing fasteners.
▪
There is no visible damage.
5
Battery charger
▪
Make sure that the battery charger is correctly
installed, and in good condition.
▪
Make sure there is no visible damage.
6
Pothole protection device
▪
Make sure there are no loose or missing parts.
▪
Make sure there is no visible damage.
▪
Make sure there is no dirt or obstructions.
1 2
3
4
6
5

Skyjack SJ12 Specifications

General

Gradeability	25%
Drive Motor	24V DC
Machine Width	32 in (0.81 m)
Stowed Height	6.5 ft
Overall Width	32 in (0.81 m)
Stowed Height (Rails Folded)	6.5 ft
Drive Speed (Elevated)	0.5 mph (0.8 km/h)
Power Source	Electric