Skyjack SJ45T User Manual

Section 3 - Operation Component Identification (Special Options)
3.6 Component Identification (Optional
Equipment/Attachments)
The following descriptions are for identification,
explanation and locating purposes only.
3.6-1 Tire Sealant (If Equipped)
This option is identied with a tire sealant label located
at the rim of the wheel.
1
2
Figure 3-2. Tire Sealant Label
Tire Sealant Label - This label indicates that tire sealant
is present inside the tires.
1. Tire Valve Stem Cap - This green valve stem cap
is substituted onto air tires to indicate sealant has
been installed.
2. Sealant - This symbol signies that tire is equipped
with sealant.
WARNING
The operator must properly handle tires
with sealant.
• When depressurizing, inflating or
checking tire pressure, ensure that
valve stem is at the top to prevent
sealant from entering the stem (refer
to Figure 3-2).
• If tire no longer holds pressure, replace
tire.
WARNING
The sealant contains propylene glycol.
Do not ingest, inhale or get into eyes. If
it gets into your eyes, ush with water for
15 minutes. Consult physician.
3.6-2 AC Outlet on Platform (If Equipped)
This outlet is a source of AC power on the platform. The
outlet is located on the right side of platform control
console and the plug is located beside hydraulic tank
in control compartment.
Figure 3-3. AC Outlet and Electrical Plug
3.6-3 Cold Weather Start (If Equipped)
The battery warmer/hydraulic oil heater cord is located
on the engine compartment near the battery.
1
Figure 3-4. Battery Warmer/Hydraulic Oil Heater Cord
1. Battery Warmer/Hydraulic Oil Heater Cord - This
cord is plugged into the AC outlet at least 4 hours
before starting engine when temperature gets
below -10°C (+14°F).
SJ 40T & SJ 45T
SJ 61T & SJ 66T
Page 47

Skyjack SJ45T Specifications

General

Brand	Skyjack
Model	SJ45T
Category	Boom Lifts
Language	English