Skyjack SJ45T User Manual

It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
contained in this operating manual and on the aerial platform.
FAMILIARIZATION
• Test Emergency Power
1. On base control console, push in “ ”
emergency stop button to turn engine off.
2. On platform control console, push in “ ”
emergency stop button.
CAUTION
When operating on auxiliary power, do
not operate more than one function
at a time to avoid overloading 12-Volt
auxiliary pump motor. Do not use
emergency power unit continuously for
more than two minutes.
NOTE
To conserve battery power, test each
function through a partial cycle.
WARNING
Ensure that there are no personnel or
obstructions in test area and there is
sufcient room for boom to swing.
3. On base control console, pull out “ ”
emergency stop button.
4. Select “ ” emergency power position
from start/function enable/emergency
power (start/emergency power) switch
and activate each boom function.
Result: All selected functions should
operate.
NOTE
The emergency power unit has two-
minute duty cycle.
• Test Off/Base/Platform (Base/Off/Platform)
Switch
1. Ensure “ ” emergency stop button is
pulled out.
2. Start engine.
3. On base control console, turn off/base/
platform (base/off/platform) key switch to
“ ” off position.
Result: Engine should shut down and
aerial platform functions should not
operate.
4. On base control console, turn off/base/
platform (base/off/platform) key switch
to “ ” platform position.
Emerg e n cy
Stop
Base Control
Console
Off/Base/Platform
Key Switch
Start/Function
Enable/Emergency
Power Switch
Start/
Emergency
Power
Switch
Base/Off/
Platform Key
Switch
Base Control
Console
Function
Enable Switch
SJ 40T & SJ 45T
SJ 61T & SJ 66T
Page 31
Section 2 - Familiarization Function Tests

Skyjack SJ45T Specifications

General

Brand	Skyjack
Model	SJ45T
Category	Boom Lifts
Language	English