EasyManua.ls Logo

Skyjack SJ4732 - Page 154

Skyjack SJ4732
177 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
154
SJ3220, SJ3226, SJ4720, SJ4726, SJ4732223198ABA
Section 5 – Procedures Skycoded Module
Menu Selection Sub-Menu Description
ANALOGS
(CONT.)
P2-6 Not used
JOYSTICK
ANALOGS
Displays Joystick M2 CANBus signals (not used)
OUTPUTS
PUMPMODE Displays state of Pumpmode setting
P1-5 Displays state of P1-5 CANbus High signal (if equipped)
P1-6 Displays state of P1-6 CANbus Low signal (if equipped)
P1-7 Displays state of P1-7 output (not used)
P1-8 Displays state of P1-8 output (PL-1 & PL-2 Overload lamp)
P1-9 Displays state of P1-9 output (BP-29 All-Motion, Tilt and Overload Beeper)
P2-9 Displays state of P2-9 output (FL-22 Flashing Light)
P5-1 Displays state of P5-1 output (C1 Motor Contactor)
P5-2 Displays state of P5-2 output (Forward Drive)
P5-3 Displays state of P5-3 output (Reverse Drive)
P5-4 Displays state of P5-4 output (Brake release)
P5-5 Displays state of P5-5 output (Lift UP)
P5-6 Displays state of P5-6 output (Steer Left)
P5-7 Displays state of P5-7 output (deck extend) (if equipped)
P5-8 Displays state of P5-8 output (Steer Right)
P5-9 Displays state of P5-9 output (Torque Mode high speed select)
P5-10 Displays state of P5-10 output (deck retract) (if equipped)
P5-11 Displays state of P5-11 output (lower valve) (CE only)
P5-12 Displays state of P5-12 output (Holding Valves)
FEEDBACK
Press ENTER to display this sub-menu to view feedback status of outputs
P5-1 Displays P5-1 (C1 Motor Contactor) output status – LO when off, HI when on
P5-x
Displays output status of all other P5 outputs (except P5-1 above) (ie: valves) – LO when all valves off, HI when
any valve on
JOYSTICK
OUTPUTS
Displays output status of Joystick M1 CANBus signals (not used)
LOG
CALDATE Displays date entered by operator at end of last calibration
SOFTWARE Displays software version of Control Module CM1
POWERED Displays total time that Control Module CM1 has been powered
MAX.BATTERY Displays maximum recorded battery supply voltage
WORKTIME Displays total time that the pump has been powered
Skycoded Control Module Menu Table (Continued)

Table of Contents

Other manuals for Skyjack SJ4732

Related product manuals