SJ643 TH & SJ843 TH 216201ADA
41
Visual & Daily Maintenance Inspections Section 4 – Pre-operation
10
Engine Intake Air Filter
▪
Ensure there are no loose or missing parts and
there is no visible damage.
▪
Ensure air cleaner vaccuator valve
11
is free
from dirt or dust by squeezing the valve lips.
▪
Check air cleaner service indicator
12
and
replace lter element if needed.
13
Fuel Tank
IMPORTANT
Before using your telehandler ensure there is
enough fuel for expected use.
▪
Ensure fuel ller cap is secure.
▪
Ensure tank shows no visible damage and no
evidence of fuel leakage.
▪
Fuel Leaks: Failure to detect and correct fuel
leaks will result in an unsafe condition. An
explosion or fuel re may cause death or serious
injury. Perform a visual inspection around the
following areas:
▪
hoses and ttings
▪
fuel pump
▪
fuel lter
▪
fuel tank
WARNING
Engine fuels are combustible. Inspect the
telehandler in an open, well-ventilated area away
from heaters, sparks and ames. Always have an
approved re extinguisher within easy reach.
14
Hydraulic Oil Tank
▪
Ensure hydraulic ller cap is secure.
▪
Ensure tank shows no visible damage and no
evidence of hydraulic oil leakage.
15
Hydraulic Oil
▪
Be sure that the boom is in the lowered and
stowed position, and then visually inspect the
sight gauge located at the rear of the hydraulic
oil tank.
▪
Add fresh, clean hydraulic oil as required.
Refer to Section 7.4 for recommended oil type.
10
12
11
14
13
15
Right Side
To Next Page
Loading...
