SMA Solar Technology AG Activation and Deactivation
Technical Description SI5048-TEN093630 61
4. Wait 5 seconds.
☑ The Sunny Island skips the QCG and the notice
shown here is displayed.
5. Presss <ENTER> and hold.
☑ The remaining time is shown on the display as
beams.
☑ On a slave the notice shown here is shown until
the master is started.
6. Press <ENTER> on the master.
☑ There is peep. The Sunny Island is in operatin and the green (top) LED is on.
9.2 Stopping the Sunny Island (Standby)
Proceed as follows to stop the Sunny Island:
1. Press <ENTER> or <ESC> to stop the Sunny Island.
☑ The notifications shown here are issued.
2. Press and hold <ENTER>.
☑ The remaining time is shown on the display as
beams.
☑ The Sunny Island is stopped. The notification shown
here are issued.
Standby
Even in standby mode the Sunny Island still requires about 4 W of power from the battery.
To Next Page
Loading...
