SMART GX Series - Connecting to a Network

Chapter 2 Installing the display
smarttech.com/kb/171861 24
3. Configure the network to enable broadcast service.
4. Configure the network to allow mDNS (multicast).
Connecting to a network
The display requires a network and internet
connection for downloading software and firmware
updates. You can connect to a network using Wi-Fi
or one of the RJ45 Ethernet jacks.
Important
Do not use the RJ45 jack on an OPSPC to connect to a network.
Note
The display’s network connection is shared internally with an OPSPC.
Tip
If you’re using one of the display’s RJ45
jacks to connect to an Ethernet network,
you can connect the other jack to a
computer to provide network access for the
computer. This is particularly useful if there
is only one wired network connection in the
room. (Network access is available when
the display is on, but not when it’s in
Standby mode).