Chapter 2 Installing the display
smarttech.com/kb/171861 25
Connecting power and turning on the display for
the first time
To connect the display to power
Connect the supplied power cable from the AC power inlet on the back of the display to a power
outlet.
Note
Refer to the display’s specifications for power requirements and power consumption information
(see
More information
on page14).
To turn on and set up the display for the first time
Important
l
Install the OPS PC module before you turn on the display.
l
The display's first-time setup procedure will not complete successfully if you try to connect to a
Wi-Fi network that requires a user name. If you would like to connect the display to a Wi-Fi
network that requires a user name, you can do that after you complete the first-time setup. For
more information, see
To connect to a Wi-Fi network
on page27.
To Next Page
Loading...
