Chapter 4 Maintaining the display
smarttech.com/kb/171861 53
2. Flick the power switch (beside the AC power inlet) on the bottom of the display's rear surface to the
OFF (O) position.
To turn the display on
Flick the power switch (beside the AC power inlet) on the bottom of the display's rear surface to the
ON (I) position.
To turn the display on or off (with an OPS module installed)
l
If
PC
is currently set as the default input in display settings (see
Startup and shutdown
in
System
on
page79), the OPS module will start automatically when the display is turned on.
l
When the OPS module is turned off, it is then safe to turn off the display using the steps listed above
in
To turn the display off
.
Cleaning and maintaining the display
Checking the display installation
Inspect the display installation frequently to ensure that the display remains securely installed.
l
Check the mounting location for signs of damage or weakness that can occur over time.
l
Check for loose screws, gaps, distortions, or other issues that could occur with the mounting
hardware.
If you find an issue, contact a trained installer.
To Next Page
Loading...
