Chapter 2 Installing the display
smarttech.com/kb/171861 27
7.
Set a password for the screen lock feature, and then tap Enter.
Important
Ensure the screen lock passcode is made available to authorized users of the display. Users must
enter the passcode to unlock the display’s screen when the Screen lock feature is enabled.
The Done screen indicates setup is finished.
Configuring network settings
Use the procedures in this chapter to update network settings after turning on the display. The chapter
describes:
l
Connecting to a Wi-Fi network
l
Configuring network proxy settings for a Wi-Fi network
l
Installing a digital network certificate for a Wi-Fi network
l
Connecting to an Ethernet network
l
Adding a VPNconnection
Note
When the display is connected to a network using Wi-Fi its Ethernet connection will be turned of (and
vise-versa).
To connect to a Wi-Fi network
1.
On the Home screen, tap the Wi-Fi icon in the top-right corner.
OR
On the Home screen, tap the Apps icon and then tap the Settings icon > Network > Wi-Fi.
2.
Turn the Wi-Fi switch on.
3. Select a wireless network.
If the Wi-Fi network is not password protected, the display connects to the network.
OR
If the network requires a password, enter the Wi-Fi password and tap Connect. Options are also
available for adding a certificate and accessing the advanced setting to configure Proxy and IP
Settings.
To Next Page
Loading...
