Appendix 8 Adjusting Input settings
smarttech.com/kb/171861 86
Source settings
Option Values Function Notes
Inputs
Select an input PC
Android
HDMI1
HDMI2
HDMI3
Type-C1
Type-C2
DP
VGA
Select a connected computer or
other device’s input to view on the
display.
Note
The PC input appears only when
an OPS PC module is installed in
the display’s accessory slot.
A green circle appears around
the currently selected input (PC,
Android, HDMI1, HDMI2, HDMI3,
Type-C1, Type-C2, DP, or VGA).
Inputs with a connected source have
a green dot beside the input name,
rather than a gray dot. The input
name also appears in green text
rather than gray when an input is
connected.
Note
Disabled inputs do not appear in
the list of available inputs.
Screen brightness Range slider Sets the overall brightness of the
image.
[N/A]
Volume Range slider Sets the display’s volume. [N/A]
Advanced settings
Access the current input's advanced settings by tapping the three dots ••• that appear in upper right
corner of the input settings menu screen. The current input is surrounded by a green circle .
Tip
You can also open the Advanced settings menu by pressing the Settings button on the remote
control when viewing any input other than Android.
Option Values Function Notes
Audio
Note
The following settings are applicable to all inputs.
Volume 1 to 100 Sets the display’s volume [N/A]
Bass -5 to 5 Sets the bass level. This setting is only adjustable when
Custom audio mode is enabled (see
Audio modes below).
To Next Page
Loading...
