SMART GX Series - Applying a Firmware Update; Updating System Firmware; Updating System Firmware Manually

Chapter 4 Maintaining the display
smarttech.com/kb/171861 57
Updating system firmware
The display checks for firmware updates automatically when its turned on, provided the display is
connected to the internet and the Disable system updates setting is disabled (see System on page79).
The display notifies you when a firmware update is available.
To make sure the network is configured properly for firmware updates, see Network on page73.
Applying a firmware update
To apply a firmware update
1. After turning on the display, a dialog appears on the screen asking if you want to update the
display’s firmware.
2.
Tap OK to update the display’s firmware.
Note
The display may restart a number of times when a firmware update is applied.
OR
Tap Cancel to update the firmware later.
To apply a firmware update from settings
1.
On the Home screen, tap the Apps icon and then tap the Settings icon > System > System
update > Check for update.
A message lets you know whether an update is available.
2.
If an update is available and you'd like to apply it, tap OK. The display applies the firmware update
automatically after a short time.
Note
The display may restart a number of times when a firmware update is applied.
Updating system firmware manually
You can download system firmware updates at smarttech.com/downloads and update the display's
firmware manually using a USB drive.