Appendix 9 Managing your display using RS-232
smarttech.com/kb/171861 98
Firmware version commands
Get command Response
get fwversion fwversion=[Value]
Where [Value] is the firmware version.
Model number commands
Get command Response
get modelnum modelnum=[Value]
Where [Value] is one of the following:
l
sbid-gx065-v2
l
sbid-gx075-v2
l
sbid-gx086-v2
Serial number commands
Get command Response
get serialnum serialnum=[Value]
Where [Value] is the serial number.
Part number commands
Get command Response
get partnum partnum=[Value]
Where [Value] is the part number, including the revision.
Asynchronous messages
The display sends an asynchronous message when the front control panel, Settings app, or remote
control are used to change a display’s setting that can be controlled by RS-232. The display will also send
an asynchronous message if the display’s power state changes. Asynchronous messages are identified
by a pound sign (#) before the message and aren’t followed by a command prompt (>).
To Next Page
Loading...
