-36-
No.EX※※-OMZ0016
(3) Mode switching button
"I/O Configurator (NFC version)" has Administrator mode and Monitor mode.
To change parameters, operate the configurator in Administrator mode.
Administrator mode: available to change the parameters
Monitor mode: available to only read the parameters (for confirmation)
To enter Administrator mode, type a password while holding the NFC reader/writer near the NFC
antenna approach area and click [Confirm].
Default password: admin
If the password is forgotten, clear the password. The password will be cleared when the master
factory key is entered in the [Password clear] dialog box that appears by clicking [Clear password].
Then it is possible to enter administrator mode without inputting the password.]
Master key: ADMIN
Any password can be set for supervisor mode. To prevent unauthorized use, it is advisable to change
the default password when you first use the I/O Configurator.
•Troubleshooting
Read error: Confirm that the NFC reader/writer is connected to the PC.
Confirm that the NFC reader/writer is held near the NFC antenna approach area.
When frozen: Remove the NFC reader/writer from the PC and connect it again.
After taking the actions above, click Refresh.
•This password is not a password for the I/O Configurator (NFC version), but a password to
access each unit. As such, be sure to perform a password authentication operation with an
NFC reader/writer held near the NFC antenna approach area.
To Next Page
Loading...
Need help?
General
