-51-
No.EX※※-OMZ0016
Pairing and Unpairing Procedures
Pairing Procedure
Pairing a Base with a Remote
Pairing is required for communication between a Base and Remote.
A Base is paired with a Remote after they are switched to pairing enabled mode.
Pairing and registration between a Base and Remote enables wireless communication.
○Operational flow during pairing
(1) Switch the Remote to pairing enabled mode
* The pairing mode of EXW1-RD* is set by factory default.
(2) Switch the Base to pairing enabled mode
* The Base switches to pairing enabled mode using the specified protocol.
(3) Pair and register the Base and Remote.
(4) Pair and register the Base and Remote.
* Remotes are switched to pairing disabled mode automatically.
•After changing the operation mode for pairing, the mode is changed by clicking the [Reset]
button or re-supplying power so that the mode will be changed to the Remote registration or
listing for connection.
To Next Page
Loading...