-6-
No.EX※※-OMZ0016
■When handling the unit or assembling/replacing units:
•Do not touch the sharp metal parts of the connector or plug for connecting units.
•Take care not to hit your hand when disassembling the unit.
The connecting portions of the unit are firmly joined with seals.
•When joining units, take care not to get fingers caught between units.
An injury can result.
■After maintenance is complete, perform appropriate functional inspections.
Stop operation if the equipment does not function properly.
Safety cannot be assured in the case of unexpected malfunction.
■Provide grounding to assure noise resistance of the Fieldbus system.
Individual grounding should be provided close to the product with a short cable.
Notice:
Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the
equipment.
NOTE:
This device complies with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
This device complies with the Federal Communications Commission (FCC) and Innovation, Science and
Economic Development Canada license-exempt RSS (s).
To operate this device, the following two conditions must be satisfied:
(1) This device does not cause interference.
(2) This device must accept any kind of interferences, including interferences that may cause
unexpected operations.
Caution
When operating this device, follow the safety requirements for radio frequency exposure established by the
Federal Communications Commission (FCC) and Innovation, Science and Economic Development Canada,
and keep the human body (excluding fingers, hands, wrists, ankles, and feet) at least 20 cm away from the
device.
When installing this device, place it 20 cm away from the end user.
To Next Page
Loading...
Need help?
General
