SMC Networks HRSH100-A 20 Series User Manual

HRX-OM-Q026
Chapter 8 Documents
HRSH Series 8.1 Specifications
8-1
Chapter 8 Documents
8.1 Specifications
8.1.1 HRSH100/150/200/250/300-A-20-
Table 8-1 Specifications of HRS100/150/200/250/300-A-20-
Model
HRSH100-A
-20-
HRSH150-A
-20-
HRSH200-A
-20-
HRSH250-A
-20-
HRSH300-A
-20-
Cooling method
Air-cooled refrigeration
Refrigerant
R410A (HFC)
Quantity of refrigerant
kg
1.27
2.1
2.1
2.8
2.8
Control method
PID control
Ambient temperature

1

2
o
C
-20 to 45
Circulating
fluid
system
Circulating fluid

1

2
Clean water, 15 to 40% ethylene glycol aqueous solution
Operating temperature range

1
o
C
5 to 35
Cooling capacity

3
kW
10.5
15.7
20.5
25
28
Heating capacity

4
kW
2.5
3
5.5
7.5
7.5
Temperature stability

5
o
C
±0.1
Pump
capacity
Rated flow rate
(Outlet)
L/min
45 (0.43 MPa)
45 (0.45 MPa)
125 (0.5 MPa)
Maximum flow rate
L/min
120
130
180
Maximum lifting
height
m
50
80
Settable pressure range

6
MPa
0.1 to 0.5
0.1 to 0.8
Minimum operating flow
rate

7
L/min
20
25
40
Tank capacity
L
25
42
60
Port size
Rc1 (Symbol F: G1, Symbol N: NPT1)
Tank port size
Rc3/4 (Symbol F: G3/4, Symbol N: NPT3/4)
Automatic
water fill
function
(Standard)
Supply side
pressure range
MPa
0.2 to 0.5
Supply side water
temp. range
o
C
5 to 35
Automatic water fill port
size
Rc1/2 (Symbol F: G1/2, Symbol N: NPT1/2)
Over flow port size
Rc1 (Symbol F: G1, Symbol N: NPT1)
Fluid contact part material
Metal
Stainless steel, Copper (Brazing filler metal for the heat exchanger), Bronze, Brass,
Resin
PTFE, PU, FKM, EPDM, PVC, NBR, POM, PE, NR
Electrical
system
Power supply
3 phase 200 VAC (50 Hz), 3 phase 200 to 230 VAC (60Hz)
Allowable voltage fluctuation ±10% (No continuous voltage fluctuation)
Applicable
earth leakage
breaker
8
Rated
current
A
30
40
50
Sensitivity
current
mA
30
Rated operating current

5
A
14
17
25
34
36
Rated power consumption

5
kW
(kVA)
4.5 (4.9)
5.8 (6.0)
8.4 (8.7)
10.4 (11.6)
11.1 (12.2)
Noise level (Front: 1m,/height: 1m)

5
dB(A)
68
71
Water-proof specification
IPX4
Accessories
Alarm code list label 2pcs. (English 1, Japanese 1),
Operation Manual 2 copies (English 1, Japanese 1),
Y strainer (40 mesh) 25A, Barrel nipple 25A,
Anchor bracket 2 pcs. (including 6 pcs. of M8 bolts)

9
Weight (in the dry state)
kg
Approx. 180
Approx. 215
Approx. 280
1: When the ambient temperature or circulating fluid temperature is 10
o
C or below, refer to "3.2.2 Operation at low ambient temperature or low
circulating fluid temperature".
2: Use fluid for circulating fluid that conforms to:
Clean water: Water Quality Standards of the Japan Refrigeration and Air Conditioning Industry Association (JRA GL-02-1994)
15 to 40% ethylene glycol aqueous solution: Diluted with clean water, without any additives such as antiseptics. (Refer to "3.2.2 Operation at low
ambient temperature or low circulating fluid temperature" for the concentration of the ethylene glycol aqueous solution.)
DI water (pure water): Electrical conductivity 1 μS/cm or more (electrical resistivity 1MΩ・cm or less)
3: (1) Ambient temperature: 32
o
C, (2) Circulating fluid: Clean water, (3) Circulating fluid temperature: 20
o
C, (4) Circulating fluid flow rate: Rated flow
rate, (5) Power supply: 200 VAC
4: (1) Ambient temperature: 32
o
C, (2) Circulating fluid: Clean water, (3) Circulating fluid flow rate: Rated flow rate, (4) Power supply: 200 VAC
5: (1) Ambient temperature: 32
o
C, (2) Circulating fluid: Clean water, (3) Circulating fluid temperature: 20
o
C, (4) Load: Refer to the cooling capacity
shown in the specification table, (5) Circulating fluid flow rate: Rated flow rate, (6) Power supply: 200 VAC, (7) Piping length: Minimum
6: With the pressure control function using an inverter. When the pressure control function is not being used, the pump power supply frequency
setting function can be used.
7: Required flow rate to maintain the cooling capacity. When the flow rate is lower than the rated flow, use a by-pass piping set.
8: To be prepared by the user. A specified earth leakage breaker is installed for option B, B1 and S “ With earth leakage breaker”.
9: The anchor brackets (including M8 bolts x 6 pcs.) are used for fixation with the skid when this product is packed. The anchor bolts are not attached.

SMC Networks HRSH100-A 20 Series Specifications

General

Brand	SMC Networks
Model	HRSH100-A 20 Series
Category	Chiller
Language	English