GW2145 - GW1160 - GW4060 - GW4190
fig. 21 – Example of use of the delayed start to set a delay of 1 h
4.11.3 TEMPORARY DISABLING OF DEMI WATER
Press the “Start/Stop” and “Door opening” buttons simultaneously for a moment to display the
status of the “demineralised water disabling” option.
The Selection buttons can be used to deselect the use of demineralised water.
If the option is active, the message “no dE ”, meaning “No demi”, temporary disabling of demineralised water,
appears on the screen.
If the option is disabled by pressing the two keys mentioned above, the message “dE” is shown on the screen.
This option can only be used if the use of demineralised water has been activated.
The disabling option can be activated before starting the selected program, and remains active
for only one cycle, at the end of which it is deactivated automatically.
When the disabling option is active, demi water is replaced with cold water in all the phases where
it would normally be used.
To Next Page
