Smeg GW2145 - Introduction to Smeg Glassware Washers

User Manual
GW2145 - GW1160 - GW4060 - GW4190
Page 6 - 86
1 INTRODUCTION
GW2145, GW1160, GW4060, GW4190 – professional glassware washing machines, laboratory glassware washers
(GW – glassware washer).
Smeg GW1160, GW4060, GW4190 family products comply with all the prerequisites of the relevant safety regulations
and the standards in force for electrical equipment.
This manual describes products series:
• GW2145 Series, laboratory glassware washers, 45cm, without drying system.
• GW1160 Series, laboratory glassware washers, 60cm, without drying system.
• GW4060 Series: laboratory glassware washers, 60cm, equipped with forced air drying system.
• GW4190 series: laboratory glassware washers, 90cm, with forced-air drying system and side
cabinet to take detergent cans.
The diagrams and images contained in this document refer to GW4060 series. For the GW2145,
GW1160, GW4190 series the same considerations and procedures apply, unless otherwise specified.
The table below summarises the product’s main characteristics. (For a full list of models and their configurations refer
to the “LIST OF MODELS” point below).
GW – basic model
CONTROL
ELECTRONIC with MICROPROCESSOR
(with Time and Date functions)
DOOR OPENING
Automatic
DETERGENT DISPENSING
Powder detergent dispenser DD (integral in inner door)
and peristaltic pump P2
OPTIONAL DETERGENT DISPENSING
peristaltic pump P1
peristaltic pump P3 (not installable on GW2145)
CONTROL OF DETERGENT DISPENSING
Optional
DETERGENT CAN LEVEL CONTROL
Optional
TEMPERATURE CONTROL
Single Platinum PT probe (TL1)
STEAM CONDENSER
On special models with suffix “C”
(e.g. GW1160 Cxx, GW4060 Cxx, GW4190 Cxx)
DRYING SYSTEM
Yes, forced air (only on GW4060, GW4190 series)
ABSOLUTE DRYING FILTER
Optional (and only on GW4060, GW4190 series)
RAILS IN CHAMBER FOR TOP BASKET
Yes
WATER INTAKE CONNECTIONS
Mains and Demineralised
PRESET PROGRAMS
Specific LABORATORY programs, TOTAL OF 16
PROGRAMS of which 6 are CUSTOM (customisable using
SMEG TRACELOG software
1
. The software is not included
in the product’s basic outfit)
COMMUNICATION
RS232 serial (For PC or Printer)
1
The TRACELOG software enables the user to communicate with SMEG “WD” and “GW” instrument and glassware
washers.
Once the connection has been made, the user can:
- Keep a record of the disinfection cycles performed.
- Monitor the appliance’s status.
- Download new versions of the appliance’s software.
- Modify programs.
- Save the appliance parameter setup.