7.2.2 DETERGENT JERRY CAN LEVEL SENSORS - OPTIONAL SL3 for P3
The appliance can be fitted with level sensor “SL3” integral in the detergent intake pipe for the P3 optional pump,
product "WD-LS xxx" (Level Sensor; the value of xxx may vary depending on the suction nozzle configuration required
– for series WD1160, WD4060: WD-LS3060.)
).
Contact your local dealer for advice about the accessory best suited to your needs and your device.
WARNING
The electrical connection to level sensors must be made using the terminal board provided inside
the rear crosspiece (each peristaltic pump has a terminal for connection of the relative level
sensor).
This procedure must be carried out by authorised technical staff.
To Next Page
Loading...
